plugs,plugs and more plugs

[oldman_gamer]

Maybe this will work.

[Jokerswild]

Originally Posted by BrokenHalo83

If you have a blood iron you should talk to yellowhello. i think he is currently doing or has done a build recently with that board, he can steer you in the right direction. As for the pin plug in, except for the HDD it doesnt really matter which way they go in.

He can't steer anything yet He's too young to drive.

[oldman_gamer]

If you look at the 3rd pic you will notice there is a 3 plug config. for the power LED,the power LED plug is 2 prong coming from the button?Thats the first question ,what 2 pins does it go on?

[gvblake22]

The colored wires are usually the positive while the negative wires are usually black or white.

[stinger608]

Originally Posted by oldman_gamer

Maybe this will work.

Ok, the 2 wires that you are holding is most likely the power LED wires. If you will notice, there are 3 power led pins on the mother board. Leave the center one empty, and plug one wire on one side, and then skip the center pin, and plug the other one on the other end. It really is kind of a hit and miss which way these will go. I know one wire has the + and the other -. Try it one way, if the led does not come on, then you will have to switch them around, but always leave the center pin empty.

The rest of the wires that you need to be concerned with, should be marked, SW, PSW, or something along them lines. This would be the power switch. One of the other sets may just be HDD, which would be the hard drive led wire set. The reset may be marked RES or something like that.

The center picture of the wires that you are holding look to be either Audio, or USB wires. For this you really do not need to be concerned with that bunch.

[oldman_gamer]

The first pic,also comes from the power button config of wires, and, are single post of which 1 has a - and the other +,it shows nothing that I have found,in the book as of yet stating where they go.Thats ? #2 ;)

[stinger608]

Ok, lets back up here a little
I know you have your case posted, but what case did you purchase?

[Elysium]

Originally Posted by oldman_gamer

If you look at the 3rd pic you will notice there is a 3 plug config. for the power LED,the power LED plug is 2 prong coming from the button?Thats the first question ,what 2 pins does it go on?

It's the two outer ones.

And Joker, I know how to steer a bike, does that count?

[oldman_gamer]

Originally Posted by Panda Man

Check the pins on the motherboard itself, it will normally be marked + or -. If it's not marked it probably doesn't matter. Beside, trial and error :P Not like it will explode from have it on backwards.

LMAO thanks (buddy)

[oldman_gamer]

Originally Posted by yellowhello

It's the two outer ones.

And Joker, I know how to steer a bike, does that count?

as in . x . or x . . <--- (x being omitted) Its a 2 prong plug, plugging onto a 3 prong mobo. or is it ----> . . x