Final set-up

[simple_inhibition]

i had that same APEVIA X-CRUISER-BK case. it fit my DFI nF4 SLI-DR without any problems. the case looked pretty cool but i grew tired of the 120mm and 3x80mm blue led fans screaming (case only comes with 2x 80mm) also the front panels plastic retention clips are weak and have a tendency to break. just be careful if you remove the front panel to put your 80mm fans there (assuming you purchase a 120mm fan to go in the rear) i also found the side panel intake duct got in the way of my cpu cooler (thermalright xp90 alcu) so i just removed it. the temperature sensor diode cables are a bit short, but they will reach the cpu heatsink, rams and hard drives. just wont look pretty lol. also be aware that if you mount a fan in the top of the case, you wont be able to use a psu thats longer than 150mm. i managed to fit my Antec NeoHE 550 in there, but i had to remove the fan, install the psu and then re-install the fan.